Driveshaft bearings

Hi,

i am peicing together the swap from jay for my civic and got my hands on some axels for very cheap. but they didnt have the 6 bearings that go on the rods in the inner cv joint to connect the end of the axel to the tranny.

the axels only came with one bearing,

the one bearing it did have was square in shape on the outside,

i have located some new bearings and they were delivered today, the seller assures me that they are off a b18 teg, except these bearings are circular in shape on the outside.

two completley different bearings. the drive shafts were off a JDM EG6 - could this be the reason for the different shaped bearings?

just wondering if anyone knows what the b series bearings are meant to look like?

here is a little diagram explaining



thanks
scott

The bearings on mine areround with a square top (the square part sits at the top). The square part slides into the outer part of the cv, lockig it to that.

From what i can remember your new ones should be fine tho. as long as ther are the same size.

Like the pic in this link but with a square top.

http://www.kml-bearing.com.hk/common/catalog_data/14/1411/141102/image_141102_b.gif

dayum, thanks for the reply! i hope they do work!

whats everyone elces look like?