Would you like to react to this message? Create an account in a few clicks or log in to continue.


 
HomeSearchLatest imagesRegisterLog in

 :: Tech :: Wheels/Tyres
 

 machining centre bore

Go down 
3 posters
AuthorMessage
srf

srf


Posts : 179
Age : 38
Location : dudley
Joined : 2007-05-23

machining centre bore Empty
PostSubject: machining centre bore   machining centre bore EmptyMon 27 Aug 2007, 10:23 pm
any local places that do this? cus the wheels i got have a bore of 54.1 and civics are 56.1 so need 2mm machining out..

or could i just use spacers?
Back to top Go down
ezza

ezza


Posts : 7570
Age : 116
Joined : 2007-01-29

machining centre bore Empty
PostSubject: Re: machining centre bore   machining centre bore EmptyTue 28 Aug 2007, 5:42 am
forgive my tardiness but what is the 'centre bore'?

but from the sounds of it a competant machine shop should be able to do this
Back to top Go down
FrontBackSide2Side




Posts : 74
Joined : 2007-06-26

machining centre bore Empty
PostSubject: Re: machining centre bore   machining centre bore EmptyWed 29 Aug 2007, 1:04 am
where the spigot ring goes.
Back to top Go down
Sponsored content





machining centre bore Empty
PostSubject: Re: machining centre bore   machining centre bore Empty
Back to top Go down
 
machining centre bore
Back to top 
Page 1 of 1
 Similar topics
-
» Centre bore machining?
» will cp centre caps fit on cpf?
» Honda Centre Caps
» Genuine JDM wheel Centre Caps x 4
» Backyard Special - BYS - Ap1 S2000 Centre Floor Jacket -Rare

Permissions in this forum:You cannot reply to topics in this forum
 :: Tech :: Wheels/Tyres-
Jump to: